EUROM Alutherm Verre Wi-Fi 1000 Mode D'emploi page 33

Figure 12
9. Place the bracket holes (Figure 12, pos. 4) over the wall brackets (Figure 12, pos. 1).
10. Let the device (Figure 12, pos. 2) drop into the openings of the wall brackets
(Figure 12, pos. 1).
11. Use the device brackets (Figure 12, pos. 3) to mark the bottom hole position on the wall.
12. Remove the device from the wall brackets (Figure 12, pos. 1).
13. Drill two holes at the marked positions and
place the wall plugs.
14. Place the device (Figure 13, pos. 2) back on
the wall brackets (Figure 13, pos. 1).
15. Screw and tighten the device brackets
(Figure 13, pos. 4) with a large screw
(Figure 13, pos. 3) to the wall
(Figure 13, pos. 3) using a Phillips screwdriver
(Figure 13, pos. 2).
Figure 13
33