Fuel Gauge - Sym Joymax Z LW12W1-EU Manuel D'utilisation

Push the M button. The tens place stops blinking and the unit display starts blinking.
Push the S button to adjust the units place in the minute display.
 Push M button to finish clock setting.
NOTE :
• When the battery is disconnected, the clock is reset to 12:00 and starts working again when the battery
is reconnected.
• If the clock is idled about 30 seconds while setting, it will exit setting mode automatically and starts
working again.
• If the ignition switch is turned off while setting the clock, the clock will exit setting mode when the
ignition switch is turned on again.
• The clock works normally by the backup power even the ignition switch is turned off.
Battery Voltage Gauge
The battery voltage display shows current battery voltage. It is forced display about 10 seconds when the
ignition switch is turned on.
Display range: 8.0V~18.0V.
CAUTION:
• If the battery voltage is below 10.0V or above 16.0V when the ignition switch is turned on, and
the engine is hard to start or cannot be started, have your scooter checked by an authorized SYM
dealer.
• If the battery voltage is below 10.0V or above 16.0V when the engine is running, have your scooter
checked by an authorized SYM dealer.

Fuel Gauge

○
,d
This digital fuel gauge shows the fuel level. There are 7 sectors in the fuel gauge.
If the fuel tank is full, all the 7 sectors come on
The low fuel level indicator light (page 8) comes on when there's only the
first sector remains, go refuel the fuel tank immediately..
○
,b
Coolant Temperature Gauge
○
,e
This digital coolant temperature gauge displays the temperature of engine coolant.
The coolant temperature varies with changes in the weather and engine load.
If the seventh sector
and move the scooter to a safe place, and check the coolant level in the reserve
tank and the radiator fan (page 24).
comes on, when the scooter is in operation, stop the engine
○
,a
.
○
,a
10
○
,a
○
○
,a
,b