Headlight Adjustment; Rear Shock Absorber Adjustment; General Lubrication; Vehicle Data Recorder - Sym Joymax Z LW12W1-EU Manuel D'utilisation

Headlight Adjustment

Use a Phillips screwdriver to adjust the vertical adjuster ○,
Headlight aiming should be performed by an authorized SYM dealer.

Rear Shock Absorber Adjustment

This scooter is equipped with 2 rear shock absorbers ○,
preload adjustment. The standard position is 2.
 Turn the adjuster ○,
 Turn the adjuster clockwise ○,
○
,A
Contact your SYM dealer for adjustment.
NOTE :
• Do not exceed the adjuster's limit.

General Lubrication

Lubricate the below parts with either engine oil or general grease in accordance with the "Periodic
Maintenance Table" (page 32) or whenever the vehicle has been operated under wet or rainy conditions.
Clean off rusty spots and wipe off any oil or grease.
 Side stand
 Front / rear brake lever
 Throttle cables

Vehicle Data Recorder

This scooter is equipped with an ECU that can record or collect vehicle data for trouble diagnosis and
research. The data must be received by a special diagnostic tool when carrying out maintenance or
check-up. SYM will not transfer the data to any third party except:
 The owner or user agrees.
 Stipulated by laws.
 In need of lawsuit.
 For research and development, and the data is irrelevant to an individual unit or the owner.
anti-clockwise ○, to increase preload (harder).
B a
to decrease preload (softer).
b
○
.
A
. Each shock absorber has 4 positions for spring
A
○,
b
3 2 1
○
,B
,A
29
○
,A
○,
a