To Stop The Engine; How To Ride The Scooter; Break-In; Throttle Control - Sym Joymax Z LW12W1-EU Manuel D'utilisation

CAUTION:
• Check the oil and the fuel volume before starting the engine.
• To prevent unexpected movement, fully pull the clutch lever before starting the engine.
• Release the starter button immediately after starting the engine.
• If the engine cannot be started after activating the starter 3 ~ 5 seconds, please slightly open the
throttle grip then push the starter button can help starting the engine.
• Do not push the starter button for more than 10 seconds to prevent damaging the starter.
• If the engine cannot be started after several attempts, please turn the ignition switch off and wait
10 seconds for the next start.
• Do not push the starter button while the engine is running.
• The exhaust gas is toxic; please start the engine in areas with good ventilation.

To Stop the Engine

 Completely close the throttle.
 Turn off the ignition switch.
 Position the scooter on a firm, level surface with side stand / main stand down.

8. How to Ride the Scooter

Break-In

During the first 1000 km of running, follow the below guidelines to ensure your scooter's reliability and
performance.
 Avoid full throttle starts and rapid acceleration.
 Avoid hard braking.
 Ride conservatively.

Throttle Control

To accelerate, slowly open the throttle ○,
To decelerate, close the throttle ○,

Moving Off

 Make sure the side stand / main stand is up.
 Make sure the surrounding area is clear.
○
,B
.
A
.
B
19
○
,A