Publicité
Les langues disponibles
Les langues disponibles
VR 4000 Case OPT/i digital display
General
The VR 4000 Case digital display allows access to all settings that can also be entered us-
ing the Comfort control panel and the US control panel on the power source, except:
-
-
-
-
-
-
-
-
When connected to the TS 4000/5000 and TS 4000/5000 COMFORT power sources, ac-
cess to the MIG/MAG pulse synergic welding process is not possible.
System require-
The VR 4000 Case digital display function is first supported from software version 2.50.25
ments
(power source) and 1.30.1 (wire-feed unit).
Installation is possible from serial number 09370001 onwards.
Control panel
12
TIG welding process
Manual metal arc welding process
Selection of filler metal/shielding gas
Selection of wire diameter
Gas testing
Overtemperature indicator
F3 indicator
Operating mode
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use any of the functions described until you have thoroughly read
and understood the following documents:
-
this document
-
the operating instructions of the wire-feed unit, especially the safety rules
-
all documents relating to the system components, especially the safety rules
Publicité
