Publicité
Les langues disponibles
Les langues disponibles
11.0 Batteries and charging
WARNING!
Please read the owner's manual supplied with the
•
charger carefully.
Do not expose any part of the battery to direct heat
•
(i.e. naked flame, gas fire).
When charging always place your charger on a hard
•
surface in a room with good ventilation.
You should not charge your batteries in outdoor
•
conditions.
11.1 Batteries, (Fig. 11.1 - 11.4)
The batteries are contained within the drive unit located
beneath the seat, under the battery shroud.
To remove the batteries:
Release the two handle screws under the front of the
•
seat frame that connect the seat frame with the seat
module interface, ( A-Fig.11.1).
Flip the seat frame backwards and secure it with the
•
safety bar, (B-Fig.11.2).
Lift off the battery lid, (Fig.11.3).
•
Disconnect the 2 pin Anderson connectors from each
•
battery, (C-Fig.11.3).
There are straps available on each battery where they
•
can be lifted out with the front battery being removed
first, (D-Fig.11.4).
To fit the batteries please reverse the above process.
•
WARNING!
The Salsa M2 Mini is fitted with two flexible straps
•
that retain both of the handle screws, (A-Fig.11.5).
These are fitted as a safety feature and should not be
removed from the wheelchair .
If the flexible straps are missing, or either of the
•
handle screws are not in place, please stop using the
wheelchair immediately and seek assistance to check
that the handle screws and straps are fitted correctly,
(A-Fig.11.5).
Ensure both handle screws and straps are in place
•
and secure.
Rev.3.0
Fig.11.1
A
Fig.11.2
B
Fig.11.3
Fig.11.4
D
Fig.11.5
A
SALSA M
C
53
Mini
2
Publicité
