Frequently Asked Questions - Marmitek GigaView 545 Guide Utilisateur

FREQUENTLY ASKED QUESTIONS

I do not get any signal.
x
Check if the units are connected to the mains and if the channel setting [2] is
the same on both units.
x
Check if both units are in the 'ON' position [7].
x
Check if the receiving TV is on the correct A/V channel.
The signal received is poor.
x
Try another channel (the channel settings must be the same on both units).
x
Move transmitter and/or receiver from the immediate vicinity of the connected
A/V devices. These may affect the range.
x
You are (almost) out of range.
x
Changing the position of the transmitter and / or receiver a few centimetres
may rectify the problem.
x
Try again with shorter distances.
The images and sound are perfect, but the infrared return signal does not
work.
Check the following:
x
Depending on the local situation the A/V signal can reach further than the
signal of the IR receiver. Try again with shorter distances.
x
Has the IR emitter been properly connected to the AV transmitter?
x
Has the IR emitter been properly placed near the IR window of your A/V
device?
I do get images but no sound.
x
The GigaView 545 can send analogue stereo signals, such as Dolby
Surround. Digital systems such as Dolby 5.1 or Dolby Digital cannot be
transmitted.
Does the GigaView 545
x
No, WiFi uses the 2.4Ghz frequency band. The GigaView 545 uses the
5.8GHz frequency band. In cases where a 2.4GHz video transmitter
experiences interference from for instance a WiFi network, the GigaView 545
can be the right solution.
Can I combine multiple receivers?
x
Yes. However, the signal will be the same on all receivers.
Do you still have questions?
Check out www.marmitek.com for more information.
GIGAVIEW 545
TM
cause a conflict with my wireless network (WLAN) ?
9