Setting Up The Av Transmitter - Marmitek GigaView 545 Guide Utilisateur

SETTING UP THE AV TRANSMITTER

1. Connect the RCA cable to the A/V jack at the back of the A/V
transmitter [2].
2. Connect the other end of the cable to the Audio/Video OUT jacks of
the video source you want to transmit the signal from (e.g. your VCR,
DVD, Satellite or TV: connecting the transmitter to your VCR or
Satellite receiver, allows you to choose channels independent from
your main TV). If your video source is equipped with a SCART
connector use the SCART Adapter labelled Transmitter.
3. Switch your ID code switch [7] to CH1.
4. Switch the power slide switch to 'OFF'.
5. Connect the DC plug of the adapter to the DC jack, [1] at the back of
the AV Transmitter and connect the adapter to an outlet. Only use
the supplied power adapter!
6. Switch the power slide switch to 'ON'.
7. The power LED [8] will go on.
8. Position the AV transmitter in a convenient location, preferably free
on all sides. Make sure the antenna [6] is placed vertical.
6 © MARMITEK