Setting Up The Av Receiver - Marmitek GigaView 545 Guide Utilisateur

SETTING UP THE AV RECEIVER

1. Connect the RCA cable to the A/V jack at the back of the A/V
receiver [4].
2. Connect the other end of the A/V cables to your TV. If your TV has a
SCART connector, you may use the SCART adapter provided,
labelled "Receiver".
3. Switch your ID code switch [7] to CH1.
4. Switch the power slide switch to 'OFF'.
5. Connect the DC plug of the adapter to the DC jack, [1] at the back of
the A/V Receiver and connect the adapter to an outlet. Only use the
supplied power adapter!
6. Switch the power slide switch to 'ON'.
7. The power LED [8] will go on.
8. Position the A/V Receiver in a convenient location, preferably free on
all sides. Make sure the antenna [6] is placed vertical.
GIGAVIEW 545 7