Tunze Multicontroller 7096 Mode D'emploi page 87

„Sequential" - sequential pump circuit
When activated, the "night mode" function interrupts the pulse operation as soon as the aquarium lighting
goes off; all pumps remain in "Power 1" setting permanently. In the morning when the light is switched on
again, the pulse operation will start again.
When activated, the "Wavecontroller" function uses the outputs 3 and 4 whilst the "Sequential" pump
operation is active only for outputs 1 and 2.
The following function can be activated in the "min. flow for switched off pumps" field:
The circulation pumps are not switched on and off alternately, but the pumps are set variably between a
selectable output and the minimum output (30 per cent).
87