Cooke & Lewis CLIND60E Installation page 52

Care and Maintenance
EN General
WARNING: Always switch off the electricity supply before performing
maintenance work. In the event of a fault, contact customer services.
Damaged power cables should be replaced by a competent person or qualified electrician.
For domestic use only.
Never place an empty pan on the hob as this will cause the overheat sensor to switch off the
appliance automatically.
When a cooking zone has been on for a long time, the surface remains hot and shows "H" in the
display.
If the surface of the hob becomes cracked, do not use, switch off the appliance at the fused
spur and contact customer services.
Do not place rough or uneven vessels on the hob, as they could damage the glass surface.
Avoid banging pots and pans down on the hob. The induction surface is tough but not
unbreakable.
Do not put detergents or flammable materials beneath the hob.
• The appliance should be cleaned after use, allow to cool first!
• The surface of the induction hob should be cleaned as follows:
Type of residue
Limescale
Burnt-on stains
Light stains
Melted plastics
CAUTION: Avoid rubbing with any abrasive or with the base of the pans, etc,
as this will wear the markings on the top of the induction hob over time.
Clean the induction hob on a regular basis to prevent the build up of food residue.
211827_s1_s3-3663602494362-C&L-A5-IM-Easy-V01.indd 52 211827_s1_s3-3663602494362-C&L-A5-IM-Easy-V01.indd 52
Cleaning method
Apply white vinegar to the surface,
then wipe it dry with soft cloth
Clean with damp cloth and dry it
with a soft cloth
Clean with damp cloth and dry it
with a soft cloth
Use a scraper suitable for induction
glass to remove residue
Cleaning materials
Special induction cleaner
Special induction cleaner
Cleaning sponge
Special induction cleaner
18-12-2020 10:50:15 18-12-2020 10:50:15
52