Cooke & Lewis CLIND60E Installation page 10

Installation
EN Caution
• The induction hotplate must be installed by
qualified personnel or technicians. Please
never conduct the operation by yourself.
• The hob must not be installed directly above a
dishwasher, fridge, freezer, washing machine or
clothes dryer, as the humidity may damage the
hob electronics.
• Do not attempt to dismantle the appliance,
there are no user servicable parts inside.
• At the end of its life, the appliance should not
be disposed of in household waste; contact
your Local Authority for guidance.
• This hob must be connected to the mains
power supply only by a suitably qualified
person.
• Before connecting the hob to the mains power
supply, check that:
1. the domestic wiring system is suitable for
the power drawn by the hob.
2. the voltage corresponds to the value given in
the rating plate.
3. the power supply cable sections can
withstand the load specified on the rating
plate.
• To connect the hob to the mains power supply,
do not use adapters, reducers, or branching
devices, as they can cause overheating and
fire.
• The power supply cable must not touch any
hot parts and must be positioned so that its
temperature will not exceed 75ºC at any point.
• The work surface is square and level, and
no structural members interfere with space
requirements.
• The work surface is made of a heat-resistant
material.
• If the hob is installed above an oven, the oven
has a built-in cooling fan.
• The installation will comply with all clearance
requirements and applicable standards and
regulations.
• A suitable isolating switch providing full
disconnection from the mains power supply is
incorporated in the permanent wiring, mounted
and positioned to comply with the local wiring
rules and regulations. The isolating switch
must be of an approved type and provide a
3 mm air gap contact separation in all poles
(or in all active [phase] conductors if the local
wiring rules allow for this variation of the
requirements).
211827_s1_s3-3663602494362-C&L-A5-IM-Easy-V01.indd 10 211827_s1_s3-3663602494362-C&L-A5-IM-Easy-V01.indd 10
• The isolating switch will be easily accessible to
the customer with the hob installed.
• You consult local building authorities and by-
laws if in doubt regarding installation.
• You use heat-resistant and easy-to-clean
finishes (such as ceramic tiles) for the wall
surfaces surrounding the hob.
• When you have installed the hob, make sure
that:
1. The power supply cable is not accessible
through cupboard doors or drawers.
2. There is adequate flow of fresh air from
outside the cabinetry to the base of the hob.
3. If the hob is installed above a drawer or
cupboard space, a thermal protection barrier
is installed below the base of the hob.
4. The isolating switch is easily accessible by
the customer.
5. The hob should be fixed into the worktop
using the fixing brackets and sealing tape
supplied with the appliance. Do not use
silicone sealant or PVA to secure the hob.
Doing so will prevent an engineer removing
the appliance to facilitate a repair.
10 10
18-12-2020 10:50:06 18-12-2020 10:50:06