Cooke & Lewis CLIND60E Installation page 11

Les langues disponibles

Installation

General

All installation must be carried out by a competent person or qualified electrician. Before connecting the

mains supply ensure that the mains voltage corresponds to the voltage on the rating plate.

Direct Connection

This appliance must be connected directly to the mains using an omnipolar circuit breaker with a minimum

opening of 3mm between contacts.

The installer must ensure that the correct electrical connection has been made and that it complies with

the wiring diagram.

The cable must not be bent or compressed.

Regularly check the power plug and power cord for damage. If the supply cord is damaged, it must be

replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a safety

hazard.

WARNING: This is a Class I appliance and MUST be earthed.

This appliance is supplied with a 5 core mains cable coloured as follows:

Brown and Black = L or Live

Blue and Grey = N or Neutral

Green and Yellow = E or Earth

N (Blue/Grey)

L (Brown/Black)

(Green/Yellow)

Connect this appliance directly to the mains consumer unit using a 32 Amp Residual Current Device

(RCD).

To avoid the risks that are always present when you use an electrical appliance it is important that this

appliance is installed correctly and that you read the safety instructions carefully to avoid misuse and

hazards. Please keep this instruction booklet for future reference and pass it on to any future owners.

After unpacking the appliance please check that it is not damaged. If in doubt, do not use the appliance but

contact Customer Services - see end of Care & maintenance section for details.

211827_s1_s3-3663602494362-C&L-A5-IM-Easy-V01.indd 11

220-240V~

18-12-2020 10:50:06

3663602494362