Cooke & Lewis CLIND60E Installation page 26

Use
NOTE: Pressing the boost key
During boost operation power output will revert to level 9 after five minutes to avoid overheating.
Using the timer
You can set the timer from 1-99 minutes and this can be used in two ways:
1. As an alarm that does not alter any of the cooking zones.
2. As an automatic switch off function to turn off one cooking zone.
NOTE: This function only operates on one zone at a time;other active zones will continue to operate as
normal.
Using the timer as an alarm
NOTE: You can use the timer function independently of the cooking zones.
1. Switch on the hob using
2. Select the cooking zone using
3. When the indicator stops flashing, touch the timer key
4. Touch the "+" or "–" keys once to increase or decrease one minute at a time.
5. Or touch and hold the "+" or "–" keys to increase or decrease ten minutes at a time.
The timer will commence countdown and show the remaining time.
The timer will beep for 30 seconds once completed.
6. To cancel the alarm press
Using the timer to switch off a cooking zone
1. Select the cooking zone using
2. Before the indicator stops flashing, touch the timer key
3. Touch the "+" or "–" keys once to increase or decrease one minute at a time.
4. Or touch and hold the "+" or "–" keys to increase or decrease ten minutes at a time.
The timer will commence countdown and show the remaining time.
The timer will beep for 30 seconds once completed.
5. To cancel the timer, select cooking zone using
NOTE: The dot next to the selected timer controlled cooking zone will flash when the timer is operative for
example When using both timer functions together, the display will always display the time set for the
alarm first. Touch the control of the relevant cooking zone to see the remaining time before switch off is
due to occur.
211827_s1_s3-3663602494362-C&L-A5-IM-Easy-V01.indd 26 211827_s1_s3-3663602494362-C&L-A5-IM-Easy-V01.indd 26
again does not cancel this function.
.
and the power level required.
then press "–" key until display shows "00".
and select the power required.
, press
and the timer will flash "10".
and the timer will flash "10".
then press "–" key until display shows "00".
26
18-12-2020 10:50:09 18-12-2020 10:50:09