Publicité
Les langues disponibles
Les langues disponibles
Problem
Oven smokes excessively during broiling.
Flames inside oven or smoking from
oven vent.
Oven control panel beeps & displays any
F code error.
Scratches or abrasions on cooktop
surface.
Metal marks on the cooktop.
Brown streaks or specks on cooktop
surface.
Areas of discoloration with metallic sheen
on cooktop surface.
Solutions to common problems •
Solution
• Incorrect setting. Follow broil instructions in Setting Oven Controls.
• Make sure oven door is opened to broil stop position.
• Meat too close to the broil element. Reposition the oven rack to provide
proper clearance between the meat & the element. Preheat the broil
element for searing.
• Meat not properly prepared. Remove excess fat from meat. Cut remaining
fatty edges to prevent curling, but do not cut into lean.
• Broiler pan and insert wrong side up and grease not draining. Always
place insert on the broiler pan with ribs up & slots down to allow grease
to drip into pan (some models).
• Grease has built up on oven surfaces. Regular cleaning is necessary when
broiling frequently. Old grease or food spatters cause excessive smoking.
• Excessive spillovers in oven. For example this will happen for pie
spillovers or large amounts of grease left on the oven bottom. Wipe up
excessive spillovers before starting oven. If flames or excessive smoke
are present see Setting broil in the Setting Oven Controls section.
• Oven control has detected a fault or error condition. Press clear off to
clear the display & stop beeping. Try the bake or broil feature again. If the
F code error repeats, remove power from appliance, wait 5 minutes and
then repower appliance and set clock for the time of day. Try the bake or
broil feature again. If the fault recurs, record fault and call for service.
• Coarse particles such as salt or sand between cooktop and utensils can
cause scratches. Be sure cooktop surface and bottoms of utensils are
clean before usage. Small scratches do not affect cooking and will
become less visible with time.
• Cleaning materials not recommended for ceramic-glass cooktop have been
used. See Cooktop cleaning and maintenance in the Care & Cleaning
section of this Use & Care Guide.
• Cookware with rough bottom has been used. Use smooth, flat-bottomed
cookware.
• Sliding or scraping of metal utensils on cooktop surface. Do not slide
metal utensils on cooktop surface. Use a ceramic-glass cooktop cleaner to
remove the marks. See "Cooktop cleaning and maintenance" in the Care
& Cleaning section.
• Boilovers are cooked onto surface. Use razor blade scraper to remove soil.
See Cooktop Cleaning and Maintenance in the Care & Cleaning section.
• Mineral deposits from water and food. Remove using a ceramic-glass cooktop
cleaner. Use cookware with clean, dry bottoms.
BEFORE YOU CALL
21
Publicité
