Hunter X-CORE Manuel De L'utilisateur page 20

EN
PROGRAMMING THE CONTROLLER
The X-Core display shows the time and day when the controller is
idle. The display changes when the dial is rotated to indicate the
specific programming information to enter. When programming, the
flashing portion of the display can be changed by pressing the
buttons. To change something that is not flashing, press the
or buttons until the desired field is flashing.
Three programs A, B, and C, each with the ability to have four daily
start times, permit plants with different watering requirements to be
separated on different day schedules.
Setting the Date and Time
1. Turn the dial to the CURRENT TIME/DAY position.
2. The current year will be flashing. Use the
change the year. After setting the year, press the
proceed to setting the month.
3. The month and day will be in the display. The month will be
flashing and the icon will be displayed. Use the
buttons to change the month. Press the
to setting the day.
4. The day will be flashing and the
the or buttons to change the day. Press the
proceed to setting the time.
5. The time will be displayed. Use the
AM, PM, or 24 hour. Press the
will be flashing. Use the
shown on the display. Press the
Minutes will be flashing. Use the
the minutes shown on the display. The date, day, and time have
now been set.
20
All manuals and user guides at all-guides.com
or buttons to
button to
or
button to proceed
icon will be displayed. Use
button to
and buttons to select
button to move to hours. Hours
and buttons to change the hour
button to move to minute.
and buttons to change
NOTE: A basic programming rule is that whatever
symbol or character is flashing will be the item
programmed. For instance, if the hour is flashing
or
when setting the time, the hour can be changed or
programmed. For illustration purposes in this manual,
flashing characters are in GRAY type.
CURRENT TIME/DA Y
12
31