Hunter X-CORE Manuel De L'utilisateur page 30

EN
HIDDEN FEATURES (CONTINUED)
Accessing the Soak Menu:
Once the desired Cycle times for each station have been program-
med, the Cycle time can be accessed by pressing the
button.
The station will remain the same as was previously displayed
under the Cycle time (i.e. if station 2 is displayed in the Cycle
menu then Station 2 will be displayed upon pressing the
button).
NOTE: The Soak menu cannot be accessed
without a programmed Cycle time.
Setting the Soak Time:
To access the other stations, press the
NOTE: When changing the stations, if a
station without a Cycle time is encountered,
the screen will revert back to the Cycle time.
Move to the next station with a Cycle Time
and press the
30
All manuals and user guides at all-guides.com
or button.
button to return.
Once the desired station is displayed, the user can use
the or button to increase or decrease the Soak time.
The user can set the Soak time from 1 minute to 4 hours
in 1 - minute increments.
NOTE: Before 1 hour, only minutes are
displayed (e.g. 36). At 1 hour or above, the
display will change to include the hour digit
(e.g. 1:13 and 4:00).
Example of Soak screen with
only minutes
Cycle and Soak Situations:
Station 1 requires 20 minutes of watering, but after
5 minutes, runoff occurs. However, after 10 minutes
all the water is absorbed. The solution would be to
program 20 minutes for the station run
time, 5 minutes for the Cycle time, and
10 minutes for the Soak time.
The soak time is a minimum amount.
The soak time may be longer amount
depending on the remaining run times.
Example of Soak screen with
hours included
Station 10 cycle running