Hunter X-CORE Manuel De L'utilisateur page 24

EN
PROGRAMMING THE CONTROLLER
1. Turn dial to MANUAL –
ONE STATION position.
2. Station run time will flash in the
display. Use the button to move
to the desired station. You may
use the or button to select the amount of time for a station
to water.
3. Turn the dial clockwise to the RUN position to run the station
(only the designated station will water, then the controller will
return to automatic mode with no change to the previously set
program). Also see One - Touch Manual Start and Advance.
24
All manuals and user guides at all-guides.com
MANUAL-ONE STATION
1
One - Touch Manual Start and Advance
You can also activate all stations to water without using the dial.
1. Hold down the button for 2 seconds.
2. This feature automatically defaults to program A. You can select
program B or C by pressing the
3. The station number will be flashing. Press the
through the stations and use the
run times. (If no buttons are pressed for a few seconds during
step 2 or 3, the controller will automatically begin watering).
4. Press the button scroll to the station you wish to begin with.
After a 2 - second pause, the program will begin. At any time
during the manual cycle, you can use the
gate from station to station manually.
button.
button to scroll
or button to adjust station
or buttons to navi-