Hunter X-CORE Manuel De L'utilisateur page 22

EN
PROGRAMMING THE CONTROLLER
Selecting Odd or Even Days to Water
This feature uses numbered day(s) of the month for watering
instead of specific days of the week (odd days: 1st, 3rd, 5th, etc.;
even days: 2nd, 4th, 6th, etc.).
1. Press the right arrow until the cursor is over SU.
2. Press the right arrow one more time, and
Odd will appear, with the [raindrop icon].
If Odd is desired, turn the dial back to
the Run position.
3. If even day watering is desired, press the
button once. The icon and EVEN will
be displayed. You can move back and forth
from ODD to EVEN by pressing the
buttons.
NOTE: The 31st of any month and February 29th are always
"off" days if Odd watering is selected.
Selecting Interval Watering
With this option you can select interval watering from 1 to 31 days.
1. With the cursor on EVEN or ODD, press the
icon will appear and a 1 flashing in the display. Interval watering
schedule appears on the display.
2. Press the or button to select the
number of days between watering
days (from 1 to 31 days). This is called
the interval.
The controller will water the selected
program at the next start time and will
then water at the interval programmed.
Note: To exit Interval Mode (if it is not desired) press the left
arrow button until the Day of Week display is shown again.
22
All manuals and user guides at all-guides.com
Even
button once and the
MON TUE WED THU FR SAT SUN ODD EVEN
Setting Event Day(s) Off
The X-Core allows you to program a No Water Day(s). This feature
is useful to inhibit watering on specific day(s). For example, if you
always mow the lawn on Saturdays, you would designate Saturday
as a No Water Day so that you are not mowing wet grass.
1. Turn the dial to the WATER DAYS position.
2. Enter an interval watering schedule as described on page 19.
button to scroll to the No Water Days at the bottom
3. Press the
of the display. MO will be flashing.
4. Use the button until the cursor is at the day of the week you
wish to set as a No Water Day.
5. Press the button to set this day as a no water day. The
illuminate over this day.
6. Repeat steps 4 and 5 until all desired event day(s) are off.
NOTE: You also have the option in the interval
watering schedule to program Odd or Even days off.
Automatic Watering
After programming the X-Core, set the dial to the
RUN position to enable automatic execution of all
selected watering programs and start times.
System Off
Valves currently watering will be shut off after
the dial is turned to the SYSTEM OFF position
for two seconds. All active programs are
discontinued and watering is stopped. To return
the controller to normal automatic operation,
simply return the dial to the RUN position.
will
RUN
SYSTEM OFF