English
Disengaging the chain brake unlocks the chain. To
disengage the chain brake:
► Pull the front hand guard to the
front handle.
You will hear an audible click when the front hand guard
reaches the unlocked position. In this position, the chain
brake is disengaged and the saw can be switched on.
15.3 Maintaining the Chain Brake
WARNING
An improperly maintained chain brake may increase the time
needed to stop the saw chain after activation, or it may not
activate or stop the chain at all, @ 6.2. The chain brake is
subject to wear, depending on the amount of usage,
conditions under which the saw is used and other factors.
Excessive wear will reduce the effectiveness of the chain
brake and can render it inoperable.
► Your chain saw should be returned to your authorized
STIHL servicing dealer for periodic inspection and
servicing of the brake system according to the following
schedule:
– Heavy Usage: every 3 months
– Part-Time Usage: every 6 months
– Occasional Usage: every 12 months
36
position, toward the
16 Inserting and Removing the Battery
16 Inserting and Removing the Battery
16.1 Inserting the Battery
WARNING
Never use a malfunctioning, damaged, cracked, leaking or
deformed battery, @ 8. Use and store the battery only
within an ambient temperature range of 14 °F to 122 °F (- 10
°C to 50 °C), @ 8.
WARNING
To reduce the risk of unintended activation, never store the
battery in the chain saw, @ 21.2.
To insert the battery:
► Engage the chain brake, @ 15.1.
1
2
► Place the chain saw on a level surface.
► Insert the battery (1) into the battery compartment (2) until
it stops.
The battery is properly inserted when you hear a audible
click and the battery is flush with the top of the housing. In
this position, there is electrical contact between the
battery and the chain saw.
Since a new battery is not fully charged, STIHL recommends
that you fully charge the battery before using it the first time,
@ 11.2.
0458-791-8221-C