Tecno-gaz SLIM Notice D'utilisation Et D'entretien page 54

Once a year
(CEILING VERSION)
5
Once a year
(MOBILE VERSION)
6
Once a year
(WALL VERSION)
7
MU_023 Rev.2
MAINTENANCE MANUAL
Make sure the bar retention screws (1) are tightened properly. Also
check the bar horizontal arm retention screws (4). If these are not
properly fastened, adequately tighten.
To access the screws, loosen the 3 dowels (1) of the ring (2). Remove
the bar cover (3) by pulling downwards. Tighten the 4 nuts (4), the
screw (5) and the safety dowel (6). Make sure the screws (7) of the
horizontal arm are properly tightened.
Make sure the stem retention screw (1) and the arm retention screws
(2) are tightened properly.
If these are not properly fastened, adequately tighten.
Make sure the wall retention screws (1) and the horizontal arm
retention screws (2) are tightened properly.
If these are not properly fastened, adequately tighten.
28/10/2019
OPERATION AND
EN
Page 20 of 32