Publicité
GB-F-NL-20
Fig.2
Fig.3
CONTROLS
THROTTLE CONTROL (A Fig.2)
Push lever forward to increase engine speed. Pull
back to reduce engine speed.
IGNITION SWITCH (B Fig.2)
The ignition key should be inserted and turned all the
way clockwise to start engine. Let go of the key
when engine starts. Return key to center to turn
engine off. Turning the key counter-clockwise
operates the glow plug to pre-heat the glow plug
chamber prior to starting. Hold until illuminated
indicator lamp turns off (20-30 seconds) for pre-
heat.
2-WHEEL/4-WHEEL DRIVE SWITCH (C Fig.2)
Push upper half of switch down to enter 2-wheel
drive mode for increased ground speed in transport.
This will stop all PTO's and prohibit their use.
Push lower half of switch down to enter 4-wheel
drive mode for increased traction. The tractor must
be in this mode before PTO's can be enabled.
PTO SWITCH (D Fig.2)
This switch activates the cutter deck drive. Push
lower half of switch and hold until cutter deck blades
start turning. Push down on top half of switch to stop
the cutter deck blades.
STEERING WHEEL TILT CONTROL (A Fig.3)
Loosen knob and move steering wheel to desired
postion. Retighten knob.
HEADLIGHT SWITCH
(Optional equipment)-Push switch half way for
running lights. Push down fully for headlights
HAZARD LIGHTS SWITCH
(Optional equipment)- Push down for flashing hazard
lights.
TURN SIGNAL LIGHTS SWITCH
(Optional equipment)-rotate switch handle counter-
clockwise for L.H. turn and clockwise for a R.H. turn.
GB
Publicité
