Panasonic OmniVision PV-V4622-K Manuel D'instructions page 21

All manuals and user guides at all-guides.com
*Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
VCR Plus+ System Programming
Ready Checklist
Clock is set.
VCR Plus+ Setup is complete (see pp. 18 - 20).
1 Press PROG/VCR+
VCR Plus+ PROG. LIST
DATE START STOP
CH
button to display
13 SAT --:-- --:-- --
PROGRAM.
TODAY
CATEGORY : N/A SLP
SELECT :
EXIT : PROG
2
Press
VCR Plus+ PROG. LIST
to select display VCR
ENTER PLUSCODE NUMBER
Plus+ screen.
-
USING 0 - 9 KEYS
SELECT :
EXIT : PROG
3 Press NUMBER keys
VCR Plus+ PROG. LIST
to enter PlusCode number
ENTER PLUSCODE NUMBER
and press PROG/VCR+
1
button to set.
USING 0 - 9 KEYS
BACKSPACE :
To Make Corrections,
END : PROG
press
to delete number, then
repeat step 3.
• If the PlusCode number entered begins with "0,"
skip to step 5. Display in step 4 will not appear.
4 Press
VCR Plus+ PROG. LIST
to select ONCE,
ONCE
DAILY(MON-FRI)
DAILY(MON~FRI), or
WEEKLY
WEEKLY recording
frequency and press
SELECT :
END : PROG
PROG/VCR+ button to set.
5
Press
VCR Plus+ PROG. LIST
DATE START STOP CH
to select category and
13 SAT 2:20P 3:20P 02
recording speed.
TODAY ABC
CATEGORY : N/A SLP
Press
SELECT RECORD SPEED
SELECT : SET: Press PROG/VCR+
END : PROG
button to end program.
6 Press PROG/VCR+
VCR Plus+ PROG. LIST
DT START STOP CH SPD
button again to exit.
13 2 : 00 P 3 : 20P 02 SLP
-- -- : -- -- : -- -- --
-- -- : -- -- : -- -- --
• Press ADD/DLT
-- -- : -- -- : -- -- --
to delete the program.
CANCEL : ADD / DLT
SELECT : SET :
EXIT : PROG
7
Press POWER off to set the timer.
("TIMER" lights up on Multi Function Display.)
Do normal Timer Record if...
• PlusCode number is not listed for
program.
repeatedly
• the program (e.g. sports event) may
run over set stop time.
See page 17 to:
• cancel a timer recording in progress.
• review, replace, or clear program
contents.
Important for DSS/Cable Box Users
• When recording via DSS, the receiver
must be left on. When recording via
cable or antenna, DSS receiver must
be off.
• When recording via a cable box,
leave box on and tuned to channel to
be recorded.
Notes
to set.
• Do not overlap program times.
• PlusCode numbers cannot be used to
program VCR to record DSS and
cable box channels.
• Make each entry within 1 minute or
the VCR will exit setup mode.
• Once VCR Plus+ channel setup is
done, channels stay in memory. If a
power interruption occurs, VCR Plus+
channel setup may be lost. Please do
VCR Plus+ channel setup again.
POWER
SELECT/
SET
:PLAY
:STOP
:REW
:FF
PROG/
VCR+
NUMBER
keys
ADD/DLT
ACTION
21