Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Initial Setup for DSS/Cable Box
Please make all cable or antenna connections before plugging into the AC outlet.
Plugging the VCR Power Cord into an AC wall outlet starts auto channel and clock set.
How to Connect
Connect the OUT Jack on your cable box to the IN FROM ANT.
1
terminal on the VCR with the RF Cable.
Connect the OUT TO TV terminal on the rear of VCR to the ANT.
2
IN terminal on TV using the RF Cable (included accessory).
TV
VCR
VHF/UHF
Doing Initial Setup (Ready to Play)
1
Turn TV on and tune to channel 3.
• Turn on your cable box and set it to
your Public Broadcasting Station (PBS)
channel in your time zone. If you use a
DSS receiver, it must be turned off.
2
Plug VCR Power Cord into AC wall
outlet. VCR comes on and auto
channel and clock set starts.
• If screen right does not appear,
check VCR - TV connection and, if
TV is tuned to channel 3, try
switching it to channel 4.
• To change VCR's output channel,
please refer to "VCR's Output
Channel" on page 13.
10
➛ ➛ ➛ ➛ ➛
VCR
IN FROM ANT.
OUT TO TV
2
WARNING
When using "Nut type" RF coaxial cables,
tighten with fingers only. Overtightening may
damage terminals.
Plugging the AC Power Plug into an AC outlet
➛ ➛ ➛ ➛ ➛
TV Connection
Cable TV
Converter Box
IN from
ANT./CABLE
1
CH AUTO SET PROCEEDING
CANCEL : STOP
AUTO CLOCK SET
PROCEEDING
CANCEL : STOP
Publicité
