Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
Don't clean or do maintenance on the machine while it is still connected to
the power supply:
Damages to machine and injuries might occur due to unintended switching
on of the machine!
Therefore: Switch the machine off and disconnect it from the power supply
be-fore any maintenance works or cleaning is carried out
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Cleaning
Arising sawdust should be regularly removed from the inside of the band saw. Before opening the
housing cover, the device is switched off and pull the plug. After opening can be cleaned with a
brush, broom or a vacuum cleaner. Remove upon completion of each work shavings and dust
from the cooling vents of the engine.
Note:
Do not remove the chips with bare
The use of solvents, harsh chemicals or abrasive cleaners leads to damage to the
machine!
Therfore:
Bare surfaces of the machine against corrosion impregnate ( with anti-rust WD40 )
Faults or defects that may affect the safety of the machine, must be rectified immediately.
The full and regular cleaning of the machine ensures a long life and is a safety requirement.
Use only mild cleaning agent, ie gasoline, kerosene, soda etc ...
Check that the warning and safety instructions on the machine present and in perfect legible
condition regularly.
Check before every use the perfect condition of the safety devices.
When storing the machine should this not be stored in a humid room and must be protected
from the influence of weather conditions.
Check at least weekly all screws are tight.
The elimination of defects does your dealer
Repair work may be carried out by qualified personnel
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
A T T E N T I O N
hands.
There is a risk of injury from sharp or pointed chips!
When cleaning water and mild detergent if necessary use.
H I N W E I S
MAINTENANCE
Seite 35
HBS 470PROFI
Publicité
