HOLZMANN MASCHINEN HBS 470PROFI Mode D'emploi page 30

ASSEMBLY
WARNING
It is prohibited to install the machine in
explosive environments.
The installation zone must be selected
evaluating the work space required
depending on the dimension of the
pieces
to be machined,and taking into account
that a free space of at least 800 mm
must be left around the machine.It is
also
necessary to check The floor capacity
and its surface, so that the machine
base is evenly resting on its four
supports.A
power outlet and a chip-suction system
connection shall be closeto the selected
machine setting and it must be
conveniently lighted.
LIFTING
The machine can be lifted using a fork-lift truck, placing the forks
under the feet or by using a "SLING", as shown, with a lifting
capability of 2000 Kg.
POSITIONING THE MACHINE
For a correct and rational organisation of the work area :
- Install the machine in an area that will not amplify vibration or noise
- Verify that the work area is adequately illuminated.
- When placed between other machinery there should be a space of at least 80 cm. It is
necessary to anticipate sufficient space for
cutting long work pieces traversly and for the fitting of rollers or other types of support,in front
and at the rear of the table.
There are four holes for fixing the machine to the floor. When fixing to the floor it is
recommended not to over tighten the fixtures to avoid increasing vibration.It is also advisable to
place anti-vibration materials between the floor and the feet of the machine.
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
ASSEMBLY
Seite 30
HBS 470PROFI