HOLZMANN MASCHINEN HBS 470PROFI Mode D'emploi page 32

mm from the back of the blade: this can be
adjusted by srew "C"(Fig.4.5.1).
Lower saw BLADE guide
- To face plate should lightly touch the blade, to
prevent vibration during operation and ensure
correct direction of cutting. The positioning of
these face plate is controlled by screw
"A"(Fig.4.5.2), once they have been adjusted,
tighten the screw "A"(Fig.4.5.2); they should be
2 mm behind the teeth of the blade.The thrust
shaftprevents excessive backward movement of
the blade whilst in operation , and should be 1-2
mm from the back of the blade: this can be
adjusted by srew "B"(Fig.4.5.2).
SETTING BLADE GUARD & GUIDE (for 60Hz)
AJUSTING THE SAW BLADE GUARD
The adjustable saw band guard should be
positioned as close as possible to the workpiece.
To adjust the height, release the locking knob(D of
Fig.4.4.2 ) and turn the handwheel (E of Fig.4.4.2)
to adjust the guard up or down. Lock the knob
once the correct position of guard is obtained. This
operation must always be carried out while the
machine is stopped.
ROLLER BEARINGS BLADE GUIDE
The roller bearings should lightly touch the blade,
to prevent vibration during operation and ensure
correct direction of cutting. The positioning of
these bearings is controlled by screw
"A"(Fig.4.6.1), once they have been adjusted,
tighten the screw "A"(Fig.4.6.1); they should be
2mm behind the teeth of the blade.The rear
bearing prevents excessive backward movement of
the blade whilst in operation , and should be 1-2
mm from the back of the blade.
LOWER SAW BLADE GUIDE
- To roller bearing should lightly touch the blade, to prevent vibration during operation and
ensure correct direction of cutting. The positioning of these rollers is controlled by screw
"A"(Fig.4.6.2), once they have been adjusted, tighten the screw "B"(Fig.4.6.2); they should be 2
mm behind the teeth of the blade.The thrust shaftprevents excessive backward movement of the
blade whilst in operation , and should be 1-2 mm from the back of the blade: this can be adjusted
by srew "B"(Fig.4.6.2).
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
OPERATION INSTRUCTIONS
Seite 32
HBS 470PROFI