HOLZMANN MASCHINEN HBS 470PROFI Mode D'emploi page 28

Use proper safety clothing and devices when operating the machine (, safety
goggles, ear protectors, safety shoes ...)! Do not wear safety gloves for
operating because they decrease the working accuracy and they might be
pulled into the saw blade.
Before any maintenance you have to disconnect the panel saw from the
power source. Never use the plugged cable for transporting or manipulating
the machine.
General rules of security
 Keep the workshop clean: It's easy to cause accidents if the workshop is in mess.
 Don't allow strangers and children to be close to the workshops:
 Keep tools carefully: Unused tools should be kept in dry and high places where children's
hands couldn't reach to, please lock them if it's necessary.
 Be careful to choose tools: Don't use small tools or accessories to finish burdensome jobs.
 Maintain tools very carefully: Keep cleaning in order to make them perform fully.
 Keep vigilance: Keep your brain sober when working. Don't operate dynamoelectric tools
when feeling tired.
 Check broken parts and accessories: Operators should carefully check whether every part,
every accessory or every protecting equipment has been broken before intermittently using
tools in order to decide whether such objects perform again.
 Advise: It's easy to cause broken tools, even personal hurt if you don't use accessories from
original Company.
Product specific rules of security
The machine operator shall have all necessary prerequisites in oder to operate a complex machiery.
- It is prohibited to use the machine when under the influence of alcohol, drugs or medication.
- All the operators must be suitably trained for use, adjustment and operation of the machine.
- The operators must carefully read the manual paying particular attention to the warning and
safety notes. Furthermore, they must be informed on the dangers associated with use of the
machine and the precautions to be taken, and must be instructed to periodically inspect the guards
and safety devices.
- Before carrying out adjustment, repair or cleaning work, disconnect the machine from the electric
power by setting the main switch to stop.
- After an initial bedding-in period or many hours of operation, the driving belts may slacken; this
causes an increase in the tool stopping time (the stopping time must be less than 10 seconds).
Immediately tighten them.
- The working area around the machine must be kept always clean and clear, in order to have an
immediate and easy access to the switchboard.
- Never insert materials which are different from those which are prescribed for the machine
utilization. The material to be machined must not contain any metal parts.
- Never machine pieces which may be too small or too wide ithrespect to the machine capacity.
- Do not work wood which has evident defects (cracks, knots, metal parts, etc.)
- Never place hands among the moving parts and/or materials.
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
SAFETY
Seite 28
HBS 470PROFI