Publicité
Les langues disponibles
Les langues disponibles
9.1. Questions on the J4 io?
observations
I can't tilt the slats
easily.
I can't tilt the slats
properly.
The"my" position is
not working.
My "my" position
cannot be repeated.
The blind (or one of
several) does not
react as described
in the manual during
pairing or setting.
I have a wind sensor
and the blind rises to
the upper end limit
regularly or even
every hour
Despite the presence
of a wind sensor,
when it is windy, the
blind does not reach
the upper position.
I don't think the
position between the
end limits is accurate.
© 2013 Somfy SAS. All rights reserved. 06/2013
Possible causes
The remote control is not compatible.
The angular travel is incorrectly set.
The "my" position is cleared.
The angular travel is incorrectly set.
There is insufficient play in the blind
ladders.
Pairing or setting has been not
executed correctly.
The sensor is paired/set.
The battery of the Somfy io sunlight
sensor is weak.
The sensor is not paired/set.
There is insufficient play in the blind
ladders.
solutions
Pairing and using a Situo mobile io VB/
Easy Sun io/Composio io/Smoove io remote
control.
Readjust the angular travel.
Set the "my" position.
Readjust the angular travel and then reset
the "my" favourite position.
No solution by adjusting the J4 io. Recall the
«my» position from the lower end limit.
Only cut shortly the power and repeat the
procedure if necessary.
There is radio interference or the sensor is
out of reach. Position the EVB - Slim receiver
for Variation io outside the head rail.
Check whether the battery is weak and
replace it if necessary.
Refer to the corresponding guide to pair/set
the sensor.
No solution by adjusting the J4 io. Recall the
«my» position from the lower end limit.
77
Publicité
