Publicité
Les langues disponibles
Les langues disponibles
8.5. Modifying the position of the horizontal slats
This setting is only necessary when using a light sensor
and using a -90°/+90° kinematic blind (Tilting travel since
the lower end limit of 180° => slats not horizontal when the
blind rises)
• Press the up and Down buttons for 5 seconds on the control
point: The blind moves briefly.
• Press the "my" and Down buttons on the control point: the
blind moves briefly.
• Move the slats towards the horizontal position by briefly press-
ing the up or Down button on the control point.
• To confirm the horizontal slat position, press simultaneously on
the "my" and Down buttons on the control point until the blind
moves.
If necessary, it possible to perform this setting in the factory
before the final pairing
Before doing this setting, you must set the angular
travel.
9. TIPs aND REcoMMENDaTIoNs
9.1. Questions on the J4 io?
observations
The blind does not
operate.
The blind stops too
soon or too late.
Despite the presence
of a sunlight sensor,
when the sunlight is
low the blind does
not tilt the slats to the
horizontal position.
76
Possible causes
The wiring is incorrect.
The motor is hot.
The Somfy io control point battery
is low.
The control point is not compatible.
The Somfy io control point used
has not been programmed into the
actuator.
The end limits have been incorrectly
set.
The sensor is not paired/set.
The sensor is paired/set.
The "my" position is cleared.
Check the wiring and modify it if necessary.
Wait until the motor cools down.
Check whether the battery is weak and
replace it if necessary.
Check for compatibility and replace the
control point if necessary.
Use a programmed control point or program
this control point.
Readjust the end limits.
Read the sensor manual to carry out the
pairing and appropriate settings
Readjust the angular travel.
Set the "my" position.
© 2013 Somfy SAS. All rights reserved. 06/2013
solutions
Publicité
