SOMFY J406 1TN Notice Installateur page 71

c) The blind still does not move
The end limits are not set and no
Somfy control point has been stored.
Go to the section entitled 6.2 «Pre-programming the
Somfy io local control point».
or
d) The blind is fully raised or lowered
The end limits are set and the
Somfy control point has been stored.
Go to the section entitled «Operation».
6.2. Pre-programming the somfy io local control point
• Press the up and Down buttons simultaneously.
The blind moves briefly, the Somfy local
io control point is pre-programmed to the motor.
6.3. checking the motor's direction of rotation
• Press the up button:
a) If the blind raises, the direction of rotation is correct:
go to the section entitled 6.4 "Basic Settings".
b) If the blind lowers, the direction of rotation is incorrect:
press the "my" button until the blind moves, the direction of
rotation is modified.
• Press the up button to check the direction of rotation.
6.4. Basic settings
5.4.1. setting upper and lower end limits
Check that your J4 io actuator has been assembled in
the blind in the lowered position with the slats closed.
• Press the up button for 3 seconds. The blind rotates in the
up direction.
• Stop the blind using the stop on the «mushroom» button. The
end limits are set. The upper end limit is stored on the
mushroom.
© 2013 Somfy SAS. All rights reserved. 06/2013
Pre-programming the
Somfy io local control
point
a
=
b
=
Setting the end limits
a
=
b
=
Operation
71