Steinberg Systems SBS-KW-1000/10O Manuel D'utilisation page 15

GRAVITY
Scale shows active value, e.g. G9.794 for g = 9,794. Only adjust the Gravity when the scale is used in a place
where the acceleration of gravity is greatly different from the place where it was calibrated.
Press , to enter the Gravity setting. G---- shows.
Press or and , to modify the digit. Press
value. Press , to input the decimal point.
USER UNIT
The User Unit can be set from 0.000 to 9.999.
The User Unit is a named unit which is usually used in the user's region, but which is not included in the scale
by default. It is a ratio to the System Unit. For example, if the User Unit is set to 1.234 and if the System Unit
is kg, then after switching to User Unit, the scale measures the weight (1000kg), and displays the calculated
value (1234usr).
This means you have to watch up the maximal load hanging on the scale while using the user unit, to not
overload the scale because of a different displayed value!
Press , to enter the User Unit setting. „U----" shows.
EN
Press or and , to modify the digit. Press
Unit value. Press , to input the decimal point.
CALIBRATION
ENTERING CALIBRATION SETTINGS
Press twiceto enter the Password mode.
The scale displays P0000. Press or
Press or , to move the digit. Input the Calibration password: P8416.
Press , to confirm the input and to enter Calibration. CAL shows.
SYSTEM UNIT
The Scale displays the System Unit. The System Unit can be set to: kg and lb.
Press , to enter the System Unit setting. Un--- shows.
Press or and , to change the System Unit.
REV. V 2016
or ,o move the digit. Input the Gravity
or , to move the digit. Input the User
and , to modify the digits.
28
CALIBRATION GRAVITY
The Scale displays the calibrated gravity, e.g. G9.794 for g = 9,794.
Press , to enter the Gravity setting. G---- shows.
Press or and , to modify the digit. Press
to move the digit. Input the Gravity value. Press
MAX. CAP
Do NOT attempt to set Max. Cap. greater than scale's actual capacity. Overloading
causes severe harm to scale, and is very dangerous.
Press , to enter the Max. Cap. setting. 00000 shows.
Press or and , to modify the digit. Press
capacity value. Press , to input the decimal point.
ZERO DETECTION
Press , to enter the zero detection. LOAD0 shows.
Keep the scale without load and press , to display the weight code 12345. After the code is stable press
, to go to the next step.
LOAD 1 DETECTION
The scale displays LOAD1.
Load a standard weight, and press . 00000 shows.
Press or and , to modify the digit. Press
to move the digit. Input weight value. Press , to input the decimal point..
Keep the load stable and press , to display the weight code 23456.
Wait until the weight code is stable. Press , o start the weight detection.
Once the detection finished, the scale automatically enters Load2 Detection.
REV. V 2016
or ,
, to input the decimal point.
or , to move the digit. Input the max.
or ,
29
EN