Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
SYMPTOM
POWER
No power is supplied.
RECORDING
Recording cannot be performed.
Recording does not start.
PLAYBACK
The tape is running, but there's no
playback picture.
Noise bars appear in the playback
picture.
Playback picture is blurred or
interrupted.
The counter indication is blurred
during Still playback.
TAPE TRANSPORT
The tape stops during fast-forward or
rewind.
Rewinding or fast-forwarding cannot
be performed.
OTHER
The tape won't eject.
Some functions are not available.
Vertical white lines appear when
shooting a very bright object.
Bright, crystal-shaped spots appear
in the viewfinder.
The picture is blurred in the Quick
Review or Retake mode.
An error number (E01, etc.) appears
in the viewfinder.
The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might
prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Power
Adapter/Battery Charger, etc.) and clock battery; and then re-connect it and proceed as usual from the beginning.
POSSIBLE CAUSE(S)
The battery pack has not been attached correctly
(
pg. 8).
The battery pack is not charged (
The power supply has not been correctly connected
(
pg. 9).
The recording tape's Erase Protection tab is missing.
Cover the hole with adhesive tape. (Some tapes have
sliding tabs. In this case, check the position of the tab.)
The camcorder power switch has not been set to
CAMERA (
pg. 14).
The TV has not been set to its VIDEO mode or channel.
If A/V connection is used, the TV's VIDEO/TV switch has
not been set to VIDEO.
The RF unit has not been set to the correct channel.
Manual Tracking has not been performed (
The video heads are dirty or worn out. Consult your
nearest JVC dealer for head cleaning or replacement.
This is normal.
The Counter Memory Function has been activated
(
pg. 31).
The tape is already fully wound on one reel or the other.
The battery pack is running low.
The PROGRAM AE dial is set to LOCK (
This sometimes occurs when the contrast between the
background and the object is great. It is not a defect of
the camcorder.
Sunlight is directly entering the lens.
This is normal while recording in the EP mode. Some noise
may be present while recording in the SP mode (
Consult your nearest JVC dealer.
39
pg. 8).
pg. 31).
pg. 16).
pg. 11).
Publicité
