Deltaplus LV102200 Notice D'utilisation Et D'entretien page 14

- Before and during use - if in doubt.
- in the case of contact with chemicals, solvents or fuels that could affect operation.
- if it has been subjected to stress during a previous fall.
- at least every twelve months by the manufacturer or a competent organization, mandated by them.
PERIODIC REVIEW of PPE:
An examination should be performed at least every twelve months by the manufacturer, or a competent person or a
competent organization, authorized by the manufacturer. This very important check is related to the maintenance and
efficacy of the PPE and hence the user's safety. A written document authorising reuse should be obtained during this
audit in order to reuse the PPE. This document will clarify that the user's safety is linked to maintaining the efficiency and
resistance of the equipment. Replace the PPE if necessary.
In accordance with European regulations, the identification form must be completed prior to the first use of the product
and then updated and kept with the product as well as the manual by the user.
The legibility of the product labelling should be checked periodically.
STORAGE INSTRUCTIONS:
During transport and storage:
- keep the product in its packaging - keep the product away from any sharp, abrasive, objects etc...
- keep the product away from sunlight, heat, flames, hot metal, oil, petroleum products, harsh chemicals, acids, dyes,
solvents, sharp edges and structures of small diameter. These items can affect the performance of the fall arrest device.
After use, store the product in its packaging in a cool, dry, ventilated area.
INSTRUCTIONS FOR CLEANING / MAINTENANCE:
The metal parts are wiped with a cloth soaked in vaseline oil. Bleach and detergents are strictly prohibited.
Clean with soap and water, wipe with a cloth and hang in a ventilated area to dry naturally away from any direct fire or
source of heat, even for items that got wet during use. Clean the strap with a soft detergent only.
Do not use bleach, harsh detergents, solvents, gasoline or colouring, these substances can affect the performance of
product.
MARKING:
- Manufacturer identification: DELTAPLUS®
- Date (month / year) of manufacture, e.g. 02/2015
- The product reference LV102 (See reference table).
- The batch number, e.g. 15.9999
- the indication of compliance with Directive 89/686/EEC (CE symbol)
- the number of the notified body involved in the regulation of equipment (0082 or 0333)
- the number of the standard to which the product is compliant and its year: EN795 : 2012 – TYPE B
- The number of persons: « 1 USER ONLY » or « 1 person MAX », or PICTO 1 person
1
- pictogram "I" ② Read the instruction manual before use.
The legibility of the product labelling should be checked periodically.
The anchorage device must be marked with the next date of inspection.
PERFORMANCE / COMPLIANCE:
Compliance with the essential requirements of Directive 89/686/EEC, in particular in terms of design, ergonomics and
safety.
Strength >12 kN.
Meets with requirements and test standards EN363, EN364, EN365, EN354, EN362, EN795 : 2012 type B.
EN INSTALLATION INSTRUCTIONS
FOR ANCHORAGE RING LV102
The closed ring should be placed around the attachment support, to make it used as anchorage point.
See diagram below:
1 Steel D-Ring
2 ring strap
3 Support / attachment structure
This anchorage point must not be placed around corner pieces less than 30x30 mm or on greater supports which
are not compatible with the length of the lanyard. Avoid using this anchorage point on sharp edges.
LV102 Anchorage ring device UPDATE : 14.05.2015 14/104
B.P. 140 - ZAC de La Peyrolière
84405 APT CEDEX - FRANCE