Deltaplus LV102200 Notice D'utilisation Et D'entretien page 13

In case of doubt on the status of the device (traces of oxidation) or after a fall (deformation), it should not be reused and
/ or be returned to the manufacturer or a competent person mandated by them.
It is forbidden to remove, add or replace any component of the anchor without the agreement of the manufacturer.
Temperature: LV102 should be used in work environments with minimum temperatures of -40°C / maximum of +50°C.
Chemicals: Put the equipment out of service in the case of contact with chemicals, solvents or fuels that could affect the
operation.
WARNING:
The user's safety depends on the continuing efficacy of the PPE, its strength and the proper understanding of the
instructions in this manual.
WARNING: Any static or dynamic overload may damage the PPE.
The device may only be used by one person at a time.
The weight of the user, including his clothing and equipment must not exceed the maximum weight of a person
(100kg according to fall arrest standards).
WARNING:
It is dangerous to create your own fall arrest system as each safety function may interfere with another safety function.
No modification or addition or repair of the PPE may be made without prior written consent from the manufacturer nor
without using their procedures. Do not use beyond the area of use defined in the instructions for use.
The manufacturer cannot be held liable for any direct or indirect accident after a modification or use other than that
provided in this manual.
Should the anchoring device be used solely for personal protective equipment against falls and not for lifting equipment.
When the anchor is used as part of a fall arrest system, the user must be equipped with means for limiting the maximum
dynamic forces exerted on the user during a fall arrest, to a maximum of 6 kN.
Provide a safe distance from power lines or areas with an electrical hazard.
USAGE LIMITS:
Before any PPE implementation operation, set up a rescue plan to deal with any emergency that may occur during the
operation.
SHELF LIFE:
Textile products or those containing textile elements (harnesses, belts, shock absorbers etc...): maximum life of 10 years
in storage (from date of manufacture), 7 years after the first use.
The shelf life is given as an indication. The following factors can cause it to vary greatly:
- Non-compliance with the manufacturer's instructions for transport, storage and use
- "Aggressive" work environment: marine atmosphere, chemicals, extreme temperatures, sharp edges...
- Particularly intensive use
- Shock or significant constraint
- Disregard for the product item's history.
Warning: these factors can cause damage invisible to the naked eye.
Warning: certain extreme conditions can shorten the shelf life by a few days.
If in doubt, always remove the product for it to undergo either: - a review - destruction
The shelf life is not a substitute for periodic verification (minimum annually) which will assess the condition of the
product.
TO FIND YOUR LOCAL ANNUAL REVIEW CENTRE, VISIT WWW.DELTAPLUS.EU.
No modification or addition or repair of the PPE may be made without prior written consent from the manufacturer nor
without using their procedures.
Do not use beyond the area of use defined in the instructions for use.
The manufacturer cannot be held liable for any direct or indirect accident after a modification or use other than that
provided in this manual.
Do not use this equipment beyond its limits.
To ensure its working condition and therefore the safety of the user, the product should be checked systematically:
1/ visually inspect the following points:
- State of the strap or rope: no fraying, no boot cut, no visible damage at seams, no burning and no unusual narrowing.
- Condition of the metal parts: no wear, no deformation, no corrosion or oxidation.
- General condition: look for any possible damage due to ultraviolet radiation and other climatic conditions.
- State of the anchoring device: its compliance to installation instructions and recommendations,
- Condition of fasteners: tightening torques (kN) observed,
- That the general disposition of the work situation reduces the fall risk, the drop height and the pendulum movement in
the case of a fall.
- Correct operation and locking of connectors (EN362).
Specific conditions such as humidity, snow, ice, mud, dirt, paint, oil, glue, corrosion, wear of the strap or rope, etc.. can
significantly reduce the operation of the fall arrest device.
2/ in the following cases:
LV102 Anchorage ring device UPDATE : 14.05.2015 13/104
B.P. 140 - ZAC de La Peyrolière
84405 APT CEDEX - FRANCE