Netview And Management; Web Network Control - gigamedia GGM CCKIT2C Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. Netview and Management

5.1 WEB network control

1. NET CONNECTION
Before the WEB operation,need to connect this device with the network.
Note: Some models before in networking, PC must be installed machine tools in CD-ROM package of the ActiveX plug-in,
otherwise IE can not connect
Step 1: Place the device properly access network;
Step 2: Give the host computer and the devices were set IP address, subnet mask and gateway (such as network routing
equipment is not requested the allocation of the IP address of the same network segment, if the network has routing
equipment, you need set up the corresponding gateway and subnet mask), the device's network settings, please check
[main menu] > [network settings].
(This device and PC need the same IP network segment. If can't connect, please check the IP of this device is connected fluent)
2. LOGIN
After the net connect,then login into.
Step 1: connect the device. Open a web browser, enter the IP address of the login
device in the address bar. As the device with IP address 192.168.1.10 for example,
then enter: http://192.168.1.10 in the address bar and connections.
If the PC connect the device at first time, when open system, the security warning
will pop up whether to accept the WEB control web.cab, please choose to accept
the user, the system will automatically identify the installation. (If the system is
prohibited to download, please confirm whether you have other prohibited
controls to download plug-ins, and reduce the IE security level)
Connection as shown below will pop up after the success of the interface.
Note: The first landing, the system will be registered, need to wait for 2/3 minutes.
Step 2: Login. Enter the user name and password, the company factory default
administrator user name admin, password is blank. After Logged ,please
promptly change the administrator password.
Login is successful, display the interface as shown below.
3. WEB CONTROL
In Picture 5.2 WEB control interface to operate WEB.
1. Menu Segment
Choose the preview mode
2. Playback
Enter into the playback mode, support 4chanel playback at the same time
3. Log
Display the log information
4. Local Configure
For WEB-side alarm settings, and checking the version information of WEB system
5. Channel Control
Select the control channel, the cursor is located in the window at controlled ac-
cess, click the right mouse button, select the corresponding channel function
operation.
When the cursor at the upper right corner of the channel, right-click, select the
corresponding channel stream type.
www.gigamedia.net
Picture 5.1 WEB Login interface
Picture 5.2 WEB control interface
EN
53

Publicité

Chapitres

Table des Matières
loading

Table des Matières