EN
3. Basic operation
3.1 Turn on
Plug the power supply and turn on the power supply switch. Power supply indicator light shining indicates turning on the
video recorder. After the startup you will hear a beep. The default setting of video output is multiple-window output mode.
If the startup time is within the video setting time, the timing video recording function will start up automatically. Then the
video indicator light of corresponding channel is shining and the DVR is working normally.
Note : Make sure that the input voltage corresponds with the switch of the DVR power supply.
Power supply demands: 220V±10% /50Hz-60Hz.
Suggest using the UPS to protect the power supply under allowable conditions.
3.2 Turn off
There are two methods to turn off the DVR. Soft-switching : Entering [right menu] and choosing [turn off] in the [turn off
the system] option; Hard-switching: Press the power button on the front panel or rear panel power switch can switch
power.
Notice: 1. Auto resume after power failure
If the DVR is shut down abnormally, it can automatically backup video and resume previous working status after
power failure.
2. Replace the hard disk
Before replacing the hard disk, the power supply switch in the real panel must be turned off.
3. Replace the battery
Before replacing the battery, the setting information must be saved and the power supply switch in the real panel
must be turned off. The DVR uses button battery. The system time must be checked regularly. If the time is not correct
you must replace the battery, we recommend replacing the battery every year and using the same battery type.
Note: The setting information must be saved before replacing the battery otherwise information will lose.
3.3 Login
When the DVR boots up, the user must login and the system provides the corresponding functions with the user purview.
There are four user settings. The names are Admin, User, Guest and Default. Admin default have no password. Default is
default user name when booting up; Admin and User are the super user at the factory presetting; Guest is the common
user at the factory presetting; Default user's factory presetting permissions are preview and playback.
3.4 Preview
You can right click mouse to choose the switch between the windows.
The system date, time and channel name are shown in each viewing window. The surveillance video and the alarm status
are shown in each window.
36
Password protection: If the password is continuous wrong three times, the alarm
will start. If the password is continuous wrong five times, the account will be
locked. (After reboot or half an hour, the account will be unlocked automatically)
For your system security, please modify your password after first login.(Chapter
4.9.3 User Managemant)
Recording status
Motion detect
Video loss
Camera lock
www.gigamedia.net