gigamedia GGM CCKIT2C Mode D'emploi page 40

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
2. Cruise between Points
Multiple preset points connected cruise lines, call cruise between points, the
PTZ run around on the line.
1) CRUISE BETWEEN POINTS SETTINGS
Cruise lines is connected by multiple preset points, setting procedure is as follows :
Step 1: In Picture 3.8, the Direction key will turn PTZ to designated location , click
Settings button to enter Picture 3.11
Step 2: Click Cruise buttons, the write proper value into the Cruise Line and Pre-
set Points blank, then click Add Preset Points button, complete setting (also can
add and delete cruise line which has been set up)
Step 3: Repeat step 1 and step 2, until set out all the preset designated cruise lines.
Remove Preset: Please input preset value in the blank, click Remove Preset button, then remove the preset points.
Remove Cruise Line: Input the number of cruise line, click Remove Cruise Lines button, then remove the cruise lines set
2) THE CALLS OF CRUISE BETWEEN POINTS
In Picture 3.8, click Page Shift button, enter PTZ control menu as shown in Picture 3.10. Please input the number of cruise
in the value blank, then click Cruise between Points button, PTZ begins to work on the cruise line. Click Stop button to
stop cruise.
3. Scan
PTZ also can work on the preset scan line repeatedly.
1) SCAN SETUP
Step 1: In Picture 3.8, click Setup button ,enter Picture 3.12
Step 2: Click Scan button, the input proper value in the scan value blank
Step 3: Click Start button, enter Picture 3.8, here you can set the following
items: Zoom, Focus, Aperture, Direction and so on. Click Setup button to go
back Picture 3.12
Step 4: Click End button to complete setup. Click the right button of the mouse to exit.
2) SCAN CALLS
In Picture 3.8, click Page Shift button, then enter PTZ control menu as shown in Picture 3.10. Please input the number of
scan in the value blank , then click Scan button, PTZ begins to work on the scan line . Click Stop button to stop.
4. Boundary Scan
In the horizontal line, set up a line, called linear sweep, PTZ repeated according to the route setting operation.
1) BOUNDARY SCAN SETUP
Step 1: In Picture 3.8, click Direction button to turn the PTZ to preset direction, then
click Setup button enter Picture 3.13, select the left boundary, return to Picture 3.8
Step 2: Please click direction arrows to adjust PTZ direction, click Setup button
enter Picture 3.13, then select the right boundary, return to Picture 3.8
Step 3: Complete setup, that is the position of left and right boundary
2) BOUNDARY SCAN CALLS
In Picture 3.8, click Page Shift button, then enter PTZ control menu as shown in
Picture 3.10. Please input the number of scan in the value blank, then click Scan
button, PTZ begins to work on the scan line . Click Stop button to stop.
40
Preset Points Blank
Cruise Line Blank
Cruise Button
Picture 3.11 Cruise Between Points Settings
Scan value blank
Scan Button
Picture 3.12 Scan Setup
Left and right
Scan setup button
Boundary Scan button
Picture 3.13 Boundary Scan Setup
www.gigamedia.net

Publicité

Chapitres

Table des Matières
loading

Table des Matières