Ptz Control - gigamedia GGM CCKIT2C Mode D'emploi

SPECIAL FUNCTIONS:
Accurate playback: Input time (h/m/s) in the time column and then click play button. The system can operate accurate
playback according to the searching time.
Local zoom: When the system is in single-window full-screen playback mode, you can drag your mouse in the screen to
select a section and then left click mouse to realize local zoom. You can right click mouse to exit.

3.5.3 PTZ control

Operation interface is as followed. The functions include: PTZ direction control, step, zoom, focus, iris, setup operation,
patrol between spots, trail patrol, boundary scan, assistant switch, light switch, level rotation and so on.
Note: 1. Decoder 485+/485- line connects with DVR 485+/485- line. The connection is right.
2. Click [main menu] > [PTZ setup] to set the PTZ parameters.
3. The PTZ functions are decided by the PTZ protocols.
[Speed] Set the PTZ rotation range. Default range: 1 ~ 8.
[Zoom] Click "-"/"+" button to adjust the zoom multiple of the camera.
[Focus] Click "-"/"+" button to adjust the focus of the camera.
[Iris] Click "-"/"+" button to adjust the iris of the camera.
[Direction control] Control the PTZ rotation. 8 directions control is supportive.
(4 directions in Front panel is supportive)
[PTZ Trace] Full-screen show channel image. Left press mouse and control PTZ
to rotate orientation. Left press mouse and then rotate the mouse to adjust the
zoom multiple of the camera.
[Set] Enter the function operation menu.
[Page Switch] Switch between different windows.
SPECIAL FUNCTIONS:
1. Preset
Set a location for the preset, calls the preset points, PTZ automatically turns to
the setting position.
1) PRESET OPTION
Set a location for the preset, procedure is as follows:
Step 1: In Picture 3.8, click the Direction button will turn into preset position,click
the Settings button to enter Picture 3.9.
Step 2: Click the Preset button , then write the preset points in the input blank,
Step 3: Click Set button, return the Picture 3.8 Complete setup, that is the preset
points and preset position corresponds.
Remove Preset: Input preset points, click Remove button, remove the preset
2) PRESET POINT CALLS
In Picture 3.8, click Page Shift button, enter PTZ control interface as shown in
Picture 3.10. In the input blank, write the preset points, then click Preset button,
PTZ turn to the corresponding preset point.
www.gigamedia.net
Picture3.8 PTZ setup
Preset point input blank
Preset button
Picture 3.9 Preset Settings
Value input blank
Picture 3.10 PTZ Control
EN
39