Video Blind; Video Loss; Alarm Input; Alarm Output - gigamedia GGM CCKIT2C Mode D'emploi

EN
[Recording delay] After alarm stop,the extended period of time to stop alarm recording, the range is 10~300 seconds.
[Screen hint] Pop the alarm information dialog box in the local host computer screen.
[Email] "■" means sending an email to user when the alarm is turned on.
Note: Set in the [network service] and send an email.
[Beep] Alarm occurs, the equipment issue "Didi" the sounds of two long ring.
[FTP upload] Alarm occurred while sending alarm events to the FTP server.

4.8.2 Video Blind

When the video image is influenced by the environment such as bad brightness
or reaching the set sensitivy parameter, the camera mask function is turned on
and the linkage function is turned on.
Note: The Advanced button with the right mouse button.
Set method: refer to Chapter 4.8.1. Motion Detect.
Picture 4.20 Video Blind

4.8.3 Video Loss

When the equipment can not obtain the channel video signal, the video loss alarm
is turned on and the linkage function is turned on.
Note: The Advanced button with the right mouse button.
Set method: refer to Chapter 4.8.1. Motion Detect
Picture 4.21 Video loss

4.8.4 Alarm input

When the equipment obtains the external alarm signal, the alarm function is
turned on.
Notice: Advanced same the right mouse button
Set method: refer to Chapter 4.8.1. Motion Detect
Picture 4.22 Alarm input

4.8.5 Alarm output

Please check current channel status: "O" means it is not in alarming status, "●"
means it is in alarming status.
You can use desktop shortcut menu or click [main menu] > [alarm function] > [alarm
output] to enter the alarm output screen.
[Configuration] Alarm is on according to the configuration.
[All] Click the all button and the according channel is alarming no matter the chan-
nel in any state.
[Stop] Click the stop button and the according channel stops alarming no matter
the channel in any state. Picture 4.23 Alarm output
www.gigamedia.net
49