Sanitas SBC 15 Mode D'emploi page 25

• The codes below are printed on batteries
containing harmful substances:
Pb = Battery contains lead,
Cd = Batter contains cadmium,
Hg = Battery contains mercury.
Setting the hour format, date and time
It is essential that you set the date and time. Otherwise,
you will not be able to save your measured values cor-
rectly with a date and time and access them again later.
There are two different ways to access the menu
from which you can adjust the settings:
• Before initial use and after each time you replace the
battery:
When inserting the batteries into the device you will be
taken to the relevant menu automatically.
• If the batteries have already been inserted:
With the device switched off press and hold the
START/STOP button
In this menu you can adjust the following settings in suc-
cession:
Hour format
for approx. 5 seconds.
Date Time
➔ ➔
Hour format
• Press and hold the START/STOP button
for 5 seconds or insert the batteries. The full
display appears.
• Select the desired hour format using the
memory button M and confirm with the
START/STOP button
Date
The year flashes on the display.
• Select the desired year using the
memory button M and confirm with
the START/STOP button
The month flashes on the display.
• Select the desired month with the memory
button M and confirm with the START/STOP
button .
The day flashes on the display.
• Select the desired day with the memory button
M and confirm with the START/STOP button
If the hour format is set as 12h, the day/month
display sequence is reversed.
25
.
.
.