probst VZ-H-UNI-KV Instructions D'emploi page 45

Operation
5.2.1 Installation versions
Version A
To lay kerb stones without gap:
•
Mount the support roller (1) as shown in
Mount the steel grippers at the holder (in upper
position) and use therefor the lower holes → see 
in Pic. A).
•
Position the device (VZ-H-UNI) with a gripped kerb
stone close on the already laid kerb stone (2) and
place on the support roller (1).
•
When opening the device (VZ-H-UNI) the kerb stone
slide downwards und lays without gap to the already
laid kerb stone.
Version B
To lay kerb stones with a gap of approx. 20 mm:
•
Mount the support roller (1) as shown in
Mount the steel grippers at the holder (in lower
position) and use therefor the upper holes → see
 in Pic. B).
•
Position the device (VZ-H-UNI) with a gripped kerb
stone close on the already laid kerb stone (2) and
place on the support roller (1).
•
To laying the kerb stone, open the device (VZ-H-UNI)
only a little, so that the lamella/steel-gripper between
the kerb stones cannot move the kerb stones.
•
Lift the device (VZ-H-UNI) and thus the lamella
causes a distance between the kerb stones.
51600031-002
Pic. 001
Pic. A
Pic. 002.
Pic. B
.
16 / 22
(1)
(2)
Pic. 001
(1)
(2)
Pic. 002
GB