Motion Alert; Instrument Setup - MSA ALTAIR 4X Manuel D'utilisation

Motion Alert

This page allows the Motion Alert feature to be activated or deactivated.
Using the three instrument buttons, the user can navigate through each
sub-menu in a top/down sequence.
Refer to section 2.3 and 7.3 in the appendix for detailed instructions on
navigating through these screens.

3.4 Instrument Setup

This section describes the configuration options that are available
through the Options Setup menus. These menus can be accessed only
when the instrument is turned ON while pressing and holding the ▲
button (see Sections 3.2 and 7.3).
This mode can only be activated at instrument turn-ON.
The operation is as follows:
1. Press and hold the ▲ button while turning the instrument ON.
• Use the ▲ and ▼ buttons to enter the setup password.
The default password is "672".
2. Press button to enter the setup menus.
• Incorrect password: instrument enters the Measure mode.
• Correct password: instrument continues/beeps three times.
The password can be changed through the MSA Link software.
In the Setup mode:
• Press the button to store chosen value or go to the next page.
• Press ▲ button to increase values by one or toggle a selection ON
or OFF.
• Press and hold ▲ button to increase values by 10.
3-8