Rear View; Voltage Selector - VINCENT SP-20 Manuel D'utilisation

+
POWER CONTROL (12V)
4. SPEAKERS: Loudspeaker terminals
At these output sockets with threaded terminals
one or two pairs of loudspeakers can be connec-
ted. Speaker cable with 4 mm banana plugs can
be used. Please take note of the information given
in the section "Installation", if two pairs of loud-
speakers will be connected to the amplifier.
5. INPUT: Input for preamplified
mono audio signal
This input must be connected with the output con-
nectors of the preamplifier for the desired chan-
nels. For example, with "PRE OUT R"/ "PRE OUT
L", if the SP-20 is to be used for the loudspeakers
of a stereo system. Do not connect any line level
sources!
6. POWER CONTROL (12V) OUTPUT
These jack connectors (3,5 mm) send the signals
for the standby control (12V Trigger).
Vincent
24

REAR VIEW

SPEAKER A
R
–
IMPEDANCE (4-
R
SPEAKER B
INPUT/EXT
DIMMER
6 7
4
INPUT
R L
Model:
SP-20
TUBE CLASS A STEREO POWER AMPLIFIER
SER NO.
POWER CONSUMPTION 800W
5
7. Dimmer: For changing the colour of the
VU-Meter.
The position of this switch affects the colour dis-
played in the VU-Meter

8. Voltage Selector:

The voltage selector behind the pane allows swit-
ching the voltage from 230 V to 110 V.
Refer to safety instructions for further information
(p. 30, "Switching the Voltage")
9. AC 220-240V: Power Connector
To establish the power supply, connect the plugs
of the power cable to the device and to a 230V
AC wall outlet. The small plastic housing beneath
the plug opening holds the fuse. Refer to the secu-
rity precautions.
SPEAKER A
L
–
+
IMPEDANCE (4-
L
SPEAKER B
~AC INLET 50/60Hz
L N
VOLTAGE SELECTOR
~115V : FUSE T10AL 250V
~230V :
FUSE T8AL 250V
8 9