Rear View - VINCENT SP-T800 Manuel D'utilisation

3
4
3. LINE IN:
Input for preamplified mono audio signal
One connector of this input must be connected
with the output connector of the preamplifier for
the desired channel. For example, with "PRE OUT
R", if the SP-T800 is to be used for the loudspea-
ker of the right-hand stereo channel. Only one of
the two input connectors can be used at any time.
The switch "XLR/RCA" must be in the correct posi-
tion. Do not connect any line level sources!
4. POWER CONTROL (12V)
These jack connectors (3,5 mm) receive and for-
ward the signal for the standby control (12V
Trigger).
Vincent
22

REAR VIEW

5 6
5. SPEAKERS: Loudspeaker terminals
At these output sockets with threaded terminals
one or two loudspeakers can be connected.
Speaker cable with 4 mm banana plugs can be
used. Please take note of the information given in
the section "Installation", if two loudspeakers will
be connected to the amplifier.
6. AC power connector and fuse holder
To establish the power supply, connect the plugs
of the power cable to the device and to the AC
wall outlet. The small plastic housing beneath the
plug opening holds the fuse. Refer to the security
precautions.
5