14. INPUT: input connectors
Here you find six stereo RCA inputs for the source
equipment for analogue stereo (line level) audio
output.
15. DIGIT L IN: Optical/Coaxial
Connections for audio signals of source devi-
ces with digital sound such as, for example,
DVD players. "Optical" for optical fibre con-
nection and "Coaxial" for connection via coa-
xial cable.
16. PRE / M IN
Connection between preamp- and output sce-
tion of the SV-737.
Attention! Please only remove the bridges if
you want to connect an external preamplifier
or an external power amplifier.
17. REC OUT: recording output
If desired, you can connect a recording device
like a CD recorder or a tape recorder to this out-
put. The stereo signal of this output is identical to
the output signal of the selected audio source at
one of the preamplifier INPUTs. It is independent
of the volume setting (5)(26), the Tone Control
(1)(2)(7). As long as the preamplifier is muted
(23), the "OUTPUT REC" does not provide the
music signal.
30
Vincent
REAR VIEW
14
15
16
17
19
22
18
20
21
18. SPEAKERS: Speaker connectors
Output sockets with screw clamps for connection
of one or two pairs of loudspeakers. You can use
loudspeaker cables with 4 mm banana connec-
tors. Please refer to the precautions in the section
"Installation" in case two pairs of loudspeakers
are connected.
19. AC 220-240V:
Power Connector with Fuse holder
Connect the plugs of the power cable to the devi-
ce and to a suitable wall outlet. The small plastic
housing holds the fuse. Refer to the security pre-
cautions.
20. POWER CONTROL (12V) OUTPUT
At these jack connectors the signals for the on/off
control (Power Control, Trigger) are emitted.
21. Voltage Selector:
The voltage selector behind the panel allows swit-
ching the voltage from 230 V to 110 V.
Refer to safety instructions for further information
(p. 36, "Switching the Voltage")
22. WIFI ANT / BT ANT
Connection for the antennas, if you want to use
the WiFi- and Bluetooth function.