Rear View; Voltage Selector - VINCENT SP-332 Manuel D'utilisation

4. SPEAKERS: Loudspeaker terminals
At these output sockets with threaded terminals
one or two pairs of loudspeakers can be connec-
ted. Speaker cable with 4 mm banana plugs can
be used. Please take note of the information given
in the section "Installation", if two pairs of loud-
speakers will be connected to the amplifier.
5. INPUT:
Input for preamplified mono audio signal
One connector type of this input (RCA or XLR)
must be connected with the output connectors of
the preamplifier for the desired channels. For
example, connected with "PRE OUT R" and "PRE
OUT L", if the SP-332 is to be used for the loud-
speakers of a stereo system. Only one of the two
input connector types can be used at any time.
The setting "XLR/RCA" (10) must be chosen cor-
rectly. Do not connect any line level sources!
6. POWER CONTROL (12V) OUTPUT
These jack connectors (3,5 mm) send the signals
for the standby control (12V Trigger).
Vincent
24

REAR VIEW

4
5 10 7
7. COLOUR VU-METER For changing the
colour of the VU-Meter.
The position of this switch affects the colour dis-
played in the VU-Meter

8. Voltage Selector:

The voltage selector behind the pane allows swit-
ching the voltage from 230 V to 110 V.
Refer to safety instructions for further information
(p. 30, "Switching the Voltage")
9. AC 220-240V: Power Connector
To establish the power supply, connect the plugs
of the power cable to the device and to a 230V
AC wall outlet. The small plastic housing beneath
the plug opening holds the fuse. Refer to the secu-
rity precautions.
10. SELECTOR: XLR/RCA
Here you can select which of the two input con-
nector types at the rear of the unit, RCA or XLR is
used.
8