Rear View - VINCENT SP-T700 Manuel D'utilisation

4
5
6
4. LINE IN: Input for preamplified
mono audio signal
This input must be connected with the output connec-
tor of the preamplifier for the desired channel. For
example, with "PRE OUT R", if the SP-T700 is to be
used for the loudspeaker of the right-hand stereo
channel. Do not connect any line level sources!
5. DIMMER:
Dimmer for the tube illumination
The setting of this switch affects the brightness of
the illumination of the tube display window (1).
6. POWER CONTROL (12V) OUTPUT
These jack connectors (3,5 mm) send the signals
for the standby control (12V Trigger).
Vincent
24

REAR VIEW

7 8 9
7. SPEAKER A/B: Loudspeaker terminals
At these output sockets with threaded terminals
one or two loudspeakers can be connected.
Speaker cable with 4 mm banana plugs can be
used. Please take note of the information given in
the section "Installation", if two loudspeakers will
be connected to the amplifier.
8. Voltage Selector:
The voltage selector behind the pane allows swit-
ching the voltage from 230 V to 110 V.
Refer to safety instructions for further information
(p. 26, "Switching the Voltage")
9. AC power connector and fuse holder
To establish the power supply, connect the plugs
of the power cable to the device and to the AC
wall outlet. The small plastic housing beneath the
plug opening holds the fuse. Refer to the security
precautions.
7