DeLonghi P60 Notice D'emploi page 44

IMPORTANT: Installation must be carried out according to
the manufacturer's instructions. Incorrect installation may
cause harm and damage to people, animals or property,
for which the manufacturer accepts no responsibility.
DETAILS
Connection to the electric power supply must be carried out by
a qualified technician and following the appropriate safety reg-
ulations.
Before carrying out the connection to the power supply, the
voltage rating of the appliance (stamped on the appliance iden-
tification plate) must be checked for correspondence to the
available mains supply voltage, and the mains electric wiring
should be capable of handling the appliance's power rating
(also indicated on the identification plate).
The appliance must be connected directly to the mains supply
by means of a heavy duty omnipolar switch with 3 mm mini-
mum distance between the contacts.
A double pole switch must be provided no further than 2 metres
from the appliance to the electrical supply. All supply current
and earth conductors must be able to withstand an ambient
temperature of 75°C.
After having installed the appliance, the power switch must
always be in a accessible position.
The appliance must have its own supply; any other appliances
installed near it must be supplied separately.
– N.B. For connections to the mains power supply, never
use adaptors, reductions or multiple power points as
these may overheat and catch fire.
– If the hob surface is cracked disconnect the appliance from
the mains.
In the event that installation should require modifications to the
mains supply wiring system it is recommended that a qualified
technician be called to carry out substitution.
The technician will also have to verify that the cross-section of the
electric cables on the power point match the appliance's power
rating.
Fig. 6.9
44
4 electrical plates models
for the OTHER COUNTRIES
A
B
F
F
E
D
Before carrying out any work on the electrical section of
the appliance, it must be disconnected from the mains.
Connection to a good earth wiring system is absolutely
essential.
The manufacturer accepts no responsibility for any
inconvenience caused by failure to comply with this rule.
ELECTRICAL CONNECTION
To connect the mains flex to the hob, proceed as follows:
Upturn the hob
Unscrew screws "A" and remove protection "B" (fig. 6.9)
Insert connecting plates "C" into terminal block "D" (Fig. 6.10)
as shown in the diagram in Fig. 6.11.
Unscrew cable clamp "E" (Fig. 6.9).
Insert correct section and type mains flex (see special chap-
ter) through mains hitch "F" of protection "B," and connect
mains and earth wires to their respective terminals in block
"D," in accordance with the diagram shown in Fig. 6.11.
Tighten mains flex, and fix it with clamp "E."
Replace protection "B," keeping flex taut.
FEEDER SPECIAL CABLE SECTION
Type "HO5V2V2-F"
resistance to temperatures of 90°C
230 VAC 50/60 Hz
400 VAC 3N 50/60 Hz
400 VAC 2N 50/60 Hz
1 2
D
C
Fig. 6.10
230 V 50/60 Hz 400 V 3N
1 2 3 4 5 1 2
PE
N L
1
(L )
2
Fig. 6.11
3 x 2,50 mm 2
5 x 1,50 mm 2
4 x 2,50 mm 2
3 4 5
C
50/60 Hz 400 V 2N
3 4 5 1 2 3 4 5
PE PE PE PE
N L L L N L
1 2 3
50/60 Hz
L
1 2