DeLonghi P60 Notice D'emploi page 35

GAS and ELECTRIC COOKING HOBS (models 580x500 mm)
FASTENING THE
INSTALLATION BRACKETS
(figs. 4.7, 4.8, 4.9)
Each cooker top is provided with an
installation kit including brackets and
screws for fastening the top to fixture
panels from 2 to 4 cm thick.
Turn the cooker top upside down and
fasten the brackets "F and R" to the
appropriate socket holes, without tight-
ening the screws "B" for the moment.
Make sure that the brackets are fas-
tened as shown in figure 4.7.
Rear side
D
Fig. 4.8
B
R
FASTENING THE
INSTALLATION BRACKETS
(fig. 4.10)
Each cooker top is provided with an
installation kit including brackets and
screws for fastening the top to fixture
panels from 2 to 4 cm thick.
Turn the cooker top upside down and
fasten the brackets "A" to the appropri-
ate socket holes, without tightening the
screws "B" for the moment.
Make sure that the brackets are fas-
tened as shown in figure 4.10.
Fig. 4.10
A
FASTENING THE COOKER TOP
Spread the sealing material "D" out along the fixture hole, making sure that the junc-
tions overlap at the corners.
Insert the cooker top into the hole and position it correctly.
Adjust the position of the brackets "F and R" and tighten screws "B" to block the cook-
er top firmly in position.
With a sharp cutter or trimmer knife trim the excess sealing material around the edge
of the cooker top.
R
Fig. 4.7
GAS COOKING HOBS (models 860x500 mm)
FASTENING THE COOKER TOP
Spread the sealing material "C" out along the fixture hole, making sure that the junc-
tions overlap at the corners.
Insert the cooker top into the hole and position it correctly.
Adjust the position of the brackets "A" and tighten screws "B" to block the cooker top
firmly in position.
With a sharp cutter or trimmer knife trim the excess sealing material around the edge
of the cooker top.
A
A
A
R
F
A
A
(figs. 4.8, 4.9)
Front side
Fig. 4.9
F
B
(fig. 4.11)
C
B
A
Fig. 4.11
D
F
35